(401) 593-1512275 W Natick Rd Ste 800, Warwick, RI 02886
Close view of a dark bronze standing-seam metal roof with a snow-guard rail, a pipe boot and a half-round gutter

Roof Replacement

Metal Roof Snow Guards: Do You Need Them in Rhode Island?

Snow slides off a metal roof in one sheet. Here is where that causes damage, what snow guards do, and what to settle before you choose metal.

By RTP RoofingPublished 5 Min Read

Build My ProjectCall (401) 593-1512

Free EstimateRTP-····-···· · Warwick Office

Free Estimate

RTP-····-····Warwick Office

Step 1 of 5 · About 1 Minute

What Does Your Home Need?

Pick the closest one. You don't need the right words for it.

Nothing is sent until you say so.

Continue

Rather Talk?(401) 593-1512

You are weighing a metal roof, and a neighbor mentions that her cousin's metal roof dumped a load of snow onto the front steps. Or you are standing at the front door in January and hear a long rumble overhead. Metal sheds snow well, and that is the exact reason it can be a problem where the snow lands.

Choosing between metal and shingles is covered in our guide to asphalt shingle vs. metal roofing in New England. This post takes a narrower question that comes up once metal is on the table: what happens to the snow, and do you need snow guards?

Why Snow Slides Off Metal

A metal panel has a smooth, painted surface that gives snow very little to hold. Snow on a shingle roof sticks to the granules and melts off over time. On metal, a layer of snow can warm from the roof side, loosen, and release all at once.

That is useful in one way. A roof that sheds its snow carries less weight through the winter. It is a hazard in another way. A sheet of snow and ice coming off a roof can weigh a lot by the time it reaches the ground, and it falls wherever the roof points.

Where Sliding Snow Does Damage

The roof itself is rarely hurt by a slide. Whatever is below it is.

  • Front and side doors, steps and walkways, where someone could be standing.
  • Gutters and downspouts, which can be bent or torn off by a falling sheet of snow.
  • A lower roof, such as a porch, garage or addition, that can take a load of snow it was not meant to carry.
  • Cars, the driveway edge, and the area where the family parks.
  • Shrubs, fences, air conditioner condensers and heat pump units next to the foundation.

Look at your own house from the street and trace what sits under each roof edge. Walk around the house and note what is under each roof edge: a door, a bed of shrubs, the neighbor's fence, the spot where the snow shovel lives. Photograph the map if it helps. That list tells you more than a general rule does, and it is the first thing a roofer will ask you about when you talk through guard placement.

What Snow Guards Do

Snow guards are small fixtures or rails attached to the roof that hold snow back, so it melts or releases in smaller pieces rather than in one slab. Layouts often use several rows across the roof instead of a single line at the edge, though the right pattern depends on the roof and the product. How many you need depends on the roof size and pitch, and the layout should be worked out by someone who has seen your roof. They come in different styles, from individual pads to long rails, and many are made in colors that match the panels so they blend in.

Not every metal roof needs them. A low-slope roof, or one over open ground with nothing under it, may need only a few in selected places. A steep roof over an entry, a walkway or a lower roof is the case where they are most worth discussing.

How They Are Attached Matters

Metal roofs move with temperature. Panels expand and contract, and a roof that is fastened in the wrong way can fight that movement and start to leak.

On a standing seam roof, the usual approach is a clamp that grips the raised seam and does not pierce the panel. On a roof with exposed fasteners, other methods are used. Fastening through the pan of a panel into the framing can interfere with that movement and open a path for water, which is why it is generally avoided. Some adhesive attachments have been reported to fail, and adhesives often have a minimum installation temperature, so ask whether the product suits the season when it will go on.

This is a question for your roofer before the work starts, not after the first winter. Ask what kind of panel is being used, how the guards attach, and whether they leave the roof's warranty intact.

Snow Guards, Ice and the Attic

Snow guards hold snow on the roof longer. That has a side effect: snow that stays put can melt from underneath and refreeze at the edge, and guards near the eave can add to icicles and ice buildup there. Preventing ice at the eave usually comes down to keeping the roof cold with good attic insulation, air sealing and ventilation. Our ice dam prevention guide covers that, and it applies to a metal roof as much as to shingles.

Adding guards to an existing roof also changes how snow loads the structure, because snow that used to slide off now stays. For that reason it is worth having a roofer look at the roof and the framing before guards are added, and an engineer if the framing is in question, and worth asking about them at the start if you are already planning a new roof.

Questions to Settle Before You Order Metal

Bring these to the estimate:

  • What sits under every edge of the roof, and who walks there?
  • Does the roof pitch and panel type call for snow guards, and where?
  • How will they attach, and does that suit the panel profile?
  • How are the gutters and any lower roofs protected from a slide?
  • What does the attic look like for insulation and ventilation?

RTP Roofing is a roofing contractor in Warwick, Rhode Island. If you are planning a metal roof, start on our metal roofing page, and ask any roofer to put the snow plan in writing.

Questions

Frequently Asked Questions

Do metal roofs need snow guards?

Not every one does. They matter where sliding snow can hurt something below, like an entry, a walkway, a gutter, a lower roof, a car or a garden bed. A steep metal roof over an open yard needs them less than one above the front door.

Does snow slide off a metal roof faster than off shingles?

Usually, yes. The smooth painted surface gives snow less to grip, so it tends to let go in a sheet instead of melting off a little at a time. That is part of why metal sheds snow well and part of why the drop needs planning.

Do snow guards make a metal roof leak?

Mostly when they are attached the wrong way. Fastening through the metal panel can restrict how the panel moves with temperature and open a path for water. On standing seam roofs, guards that clamp to the seam without piercing the panel are designed to avoid that problem.

Can snow guards be added after the roof is installed?

Often yes, but adding them changes how snow loads the roof, so it is wiser to plan them during the design instead of after the first winter. Ask your roofer to look at the roof and the framing before adding any.

Talk to a Roofer About Your Home

Questions about your own roof? Get a free estimate from RTP Roofing in Warwick, or call and talk it through.

Request an EstimateContact RTP RoofingCall (401) 593-1512

Call NowBuild My Project